SHP100-F Broadband power line cummunication cable extender module
As a simple and easy-to-use Ethernet transmission module, SHP100
can shorten the development cycle and reduce the design threshold
for users. The module provides a set of Ethernet interface and a
12V DC output (output power can be up to 5W). Users can easily
transmit data on the power line (220V AC power line) through the
module.
SHP100 is an industrial power line carrier communication module,
which adopts the technology of HD-PLC and is developed for the
industry application. The module has a high-performance broadband
carrier chip and has the characteristics of high integration and
high reliability. Shp100 uses OFDM modulation technology, the
modulation frequency band can be up to 2-28mhz, the maximum
transmission rate of physical layer can be up to 240Mbps, embedded
automatic relay routing protocol, and the maximum support level 10
relay.
Performance advantages
SHP100 has the following advantages over Homeplug AV technology:
High reliability: industrial temperature design, supporting - 40
℃ ~ 70 ℃ temperature range
Strong anti-interference: in applications with low bandwidth
requirements, anti-interference and transmission distance can be
guaranteed by closing high-frequency channel
Long transmission distance: Long transmission distance:
point-to-point communication, maximum 1.5km on armored cable,
maximum 2km on coaxial line
Support relay mode: support up to 10 levels of relay, with
transmission distance up to 10km
Strong load capacity: the maximum number of slave nodes in a
single network is 512
Low power consumption: single machine power consumption is less
than 1.2W
The input is AC-DC dual-purpose, with input voltage range (AC
85-305VAC; DC 120-432VDC)
Provide users with a 12V DC output and 5W power, which can supply
power to the user's service board
Overall dimension of module
The overall dimension of SHP100 module is 68mm x 46mm x 23.5mm. The
external interface is one channel of 220V AC input (carrier
channel), one channel of 12V DC output, one channel of Ethernet
interface, a total of 9 pins.
Module interface introduction
1:NC
2: AC(N)
3: AC(L)
4: +12V
5: GND
6:TXP ( ETH-1 )
7:TXN ( ETH-2 )
8:RXP ( ETH-3 )
9:RXN ( ETH-6 )
Order Information
Product Description Order Code
Ethernet Cable Extender SHP100-F
